•Always use the front handle and ensure a good grip on the grinder housing with one hand and the handle with the other hand before proceeding with any work.
•Make sure that the disc is not in contact with the work when you start the grinder.
•Be careful not to damage the spindle or either of the disc flanges. Damage to these parts could result in disc breakage.
•Do not press the spindle lock button whilst the spindle is turning.
•Only use good quality grinding and cut off discs. Cheap poor quality discs tend to glaze up which loads the motor and can damage it. Use discs for their designated purpose only. For instance, do not use cutting discs for grinding or metal wheels on masonry.
•Watch out for flying sparks. Hold the tool at an angle of approximately 15º to 30º to the work piece surface.
•Let the disc do the grinding or cutting at a reasonable feed, as overloading will occur if too much pressure is applied and the disc slows resulting in inefficient cutting and possible damage to the motor.
•When using the grinder, use safety equipment including safety goggles or shield, ear protection, dust mask and protective clothing including safety gloves.
ALWAYS WEAR EYE PROTECTION
Wear goggles
Wear hearing protection
Wear a breathing mask
Contents of carton
The GMC AG125MAG Angle Grinder is supplied with the following accessories as standard:
•Pin wrench
•Side handle
•125mm metal cutting disc
•Instruction manual
Unpacking
Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
6