SECTION 2: OPERATIONS
Unpacking/Inventory Removing/Installing Router Bit
The Model H7790/H7791 was carefully packed when it left our warehouse. If you discover the tool is damaged after you have signed for delivery, please immedi- ately call Customer Service at (570) 546- 9663 for advice.
Save the box and all packing materials for possible inspection by the carrier or its agent. Otherwise, filing a freight claim can be difficult.
When you are completely satisfied with the condition of your shipment, you should inventory the contents.
Model H7790/H7791 Inventory (Figure 2)
A.Router with Base Plate (Not Shown) .1
B. | Collet Wrenches | 1 |
C. | Template Guide | 1 |
D. | Straight Trim Guide | 1 |
E. | Curved Trim Guide | 1 |
D
B
C
E
Figure 2. Model H7790/H7791 inventory.
In the event that any nonproprietary parts are missing (e.g. a nut or a washer), we would be glad to replace them, or for the sake of expediency, replacements can be obtained at your local hardware store.
Model H7790/H7791 Laminate Trim Router
This router is supplied with a 1⁄4" collet for use with 1⁄4" shank router bits. It will accept router bits up to a 11⁄8" diameter. Carefully inspect router bits for cracks, chips, or other damage before installing. DO NOT use router bits that have been dropped, cracked, or damaged. The router bit may shatter causing serious injury.
To remove or install a router bit:
1.UNPLUG THE ROUTER AND MAKE SURE THE SWITCH IS OFF!
2.Loosen the lock knob and adjust the base for access to the collet.
3.Place the collet wrenches as shown in Figure 3, loosen the collet, and remove the router bit.
CAUTION: The router bit is sharp and will be hot after use. Wear gloves to prevent injury when removing bit.
Figure 3. Loosening the collet.
4.Slide the router bit to within 1⁄8" of the bottom of the collet and securely tighten the collet with the wrenches.
Note: The collet can be damaged if it is tightened without a bit.