ENGLISH
Fitting and removing grinding or cutting discs (fig. C - F) Always use the correct type of disc for your application. Always use discs with the correct diameter and bore size (see technical data). The maximum thickness for grinding discs is 6 mm, for cutting discs 3.5 mm.
Fitting
Fit the guard as described above.
Place the inner flange (11) onto the spindle (6) as shown (fig. C). Make sure that the flange is correctly located on the flat sides of the spindle.
Place the disc (12) onto the spindle (6) as shown (fig. D). If the disc has a raised centre (13), make sure that the raised centre faces the inner flange.
Make sure that the disc locates correctly on the inner flange. Place the outer flange (14) onto the spindle. When fitting a grinding disc, the raised centre on the outer flange must face towards the disc (A in fig. E). When fitting a cutting disc, the raised centre on the outer flange must face away from the disc (B in fig. E).
Keep the spindle lock (4) depressed and tighten the outer flange using the
Removing
Keep the spindle lock (4) depressed and loosen the outer flange (14) using the
Use
Warning! Let the tool work at its own pace. Do not overload.
Carefully guide the cable in order to avoid accidentally cutting it.
Be prepared for a stream of sparks when the grinding or cutting disc touches the workpiece.
Always position the tool in such a way that the guard provides optimum protection from the grinding or cutting disc.
Switching on and off
To switch the tool on, press the
To switch the tool off, release the on/off switch (1).
Warning! Do not switch the tool off while under load.
Hints for optimum use
Firmly hold the tool with one hand around the side handle and the other hand around the main handle.
When grinding, always maintain an angle of approx. 15° between the disc and the workpiece surface.
Maintenance
Your tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning.
Regularly clean the ventilation slots in your tool using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do not use any abrasive or
Technical data
|
| KG2001 |
|
Voltage | VAC | 120/220 |
|
Power input | W | 2,000 |
|
min | 8,400 |
| |
Disc diameter | mm | 180 |
|
Disc bore | mm | 22 |
|
Spindle size |
| ||
Weight | kg | 7 |
|
Service
You can check the location of your nearest authorized service center by contacting your local Black & Decker office at the
address indicated in this manual.
10