3.Adjust the Straight Guide by turning the Fine Adjustment Screw (A) to the desired distance from the bit.
4.Tighten wing nuts (C).
5.When cutting, move the router with the Straight Guide flat against the side of the material to be chamfered or grooved. See figure.
Note: Standoffs can be mounted to the Straight Guide to widen its operation. This also prevents larger bits from striking the Straight Guide.
Using the Trimmer Guide
The Trimmer Guide (3A) is used to make cuts on curved material. The guide roller rides the curve of the material.
Fine Adjustment
Screw (A)
Wing Nut (B)
Trimmer Guide (3A) 
1.Place the Trimmer Guide (3A) on the Guide Holder with the wing nut.
2.Insert Guide Holder into the holes in the router base.
3.Adjust the Trimmer Guide by turning the Fine Adjustment Screw (A) to the desired distance from the bit.
4.Tighten Wing Nut (B).
SKU 37793 | For technical questions, please call | Page 11 |