Installing and removing collets
CAUTION. Always ensure that the router is switched off and unplugged from the mains supply before installing or removing a collet.
Depending on the size of the router bit the collet may need to be changed to allow use of larger or smaller diameter router bits.
1. Depress and hold the spindle
lock button to stop the spindle2 from turning.
2.Whilst holding the spindle lock button loosen the collet nut (12) by rotating it using the wrench provided.
3.Remove the collet nut followed by the collet.
3 |
| 3 |
|
|
|
4. | Install the new collet into the assembly; this is sometimes |
| |
| easier if the router is plunged to its full depth. |
| |
5. | Install the collet nut and tighten |
|
|
| 6 | ||
| by hand. | ||
6.Firmly tighten the collet nut by depressing and holding the spindle lock button and then tightening the collet nut using the wrench provided.
WARNING. Do not tighten the collet nut without a bit in place or
you may break the centre piece of the collet.
Installing and removing router bits
CAUTION. Always ensure that the router is switched off and unplugged from the mains supply before installing or removing a router bit.
NOTE. Ensure the router bit being used has the correct shank size matching the inserted collet, that is a 1/2” router bits with the 1/2” collet. Never use the incorrect router bit in a collet of the wrong size, this can be very dangerous.
1.Loosen the collet nut (12) by depressing and holding the spindle lock button (11) and then rotating the collet nut.
2.Insert the router bit ensuring that the shaft of the bit goes all the way into the collet.
2 |
| 3 |
|
|
|
3.Tighten the collet nut assembly by depressing and holding the spindle lock button and then tightening the collet nut.
CAUTION. Ensure the bit is firmly secured before commencing operation.
Adjusting the cutting depth |
| |
CAUTION. Always ensure that |
| |
1 | ||
the router is switched off and | ||
| ||
unplugged from the mains supply |
| |
before adjusting the depth of cut. |
| |
1. Place the machine on a flat |
| |
surface and loosen the depth |
| |
gauge locking knob (5). |
| |
|
|
8