Cisco Systems AIRAP1041NAK9 specifications About this Guide, Safety Instructions

Page 2

1About this Guide

This Guide provides instructions on how to install and configure your Cisco Aironet 1040 Series Access Point. This guide also provides mounting instructions and limited troubleshooting procedures.

2Safety Instructions

Translated versions of the following safety warnings are provided in the translated safety warnings document that is shipped with your access point. The translated warnings are also in the Translated Safety Warnings for Cisco Aironet Access Points, which is available on Cisco.com.

Warning

IMPORTANT SAFETY INSTRUCTIONS

Warning

Warning

Warning

Warning

This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. Use the statement number provided at the end of each warning to locate its translation in the translated safety warnings that accompanied this device. Statement 1071

SAVE THESE INSTRUCTIONS

Read the installation instructions before you connect the system to its power source. Statement 1004

This product must be connected to a Power-over-Ethernet (PoE) IEEE 802.3af compliant power source or an IEC60950 compliant limited power source. Statement 353

Installation of the equipment must comply with local and national electrical codes. Statement 1074

This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than:

20A. Statement 1005

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Cisco Aironet 1040 Series Access Points Safety Instructions About this GuideSuch use. Statement 245B Unpacking Access Point Ports and Connections OverviewConfiguring the Access Point Controller Discovery ProcessPreparing the Access Point Installation Summary Performing a Pre-Installation ConfigurationPre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access pointsPage Page Configuring Security Settings Page Mounting the Access Point Deploying the Access Point on the Wireless NetworkChecking the Access Point LED TroubleshootingUsing Dhcp Option Status LED LED Troubleshooting the Access Point Join Process Page Declarations of Conformity and Regulatory Information Vcci Statement for Japan 03-6434-6500 Statement 371-Power Cable and AC Adapter Industry CanadaModels Page Page Declaration of Conformity for RF Exposure United StatesChinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Declaration of Conformity Statements Portuguese TranslationConfiguring Dhcp Option 43 and Dhcp Option Access Point Specifications Type + Length + ValueCategory Specification
Top Page Image Contents