Cisco Systems 78-12510-02 manual Upgrading Non-redundant RPM-PR Cards

Page 20

Chapter 5 Configuring the MGX RPM-PR

Establishing 1:N Redundancy Between Two or More RPM-PR Cards

Step 6 Continue this procedure from Step 2 for all remaining cards.

Upgrading Non-redundant RPM-PR Cards

The following procedure describes how to upgrade non-redundant RPM-PR cards.

Step 1 Configure the RPM-PR card to store its configuration on the PXM hard disk by entering the boot config e:auto_config_<slot#> command or by saving it in NVRAM by entering the WR MEM command.

Step 2 Modify the running configuration to boot from the new upgrade software by entering the boot system command.

Step 3 Enter WR MEM to save the configuration.

Step 4 Reset the RPM-PR card by entering the reset command from the PXM or the reload command from the RPM-PR.

	Cisco MGX Route Processor Module (RPM-PR) Installation and Configuration Guide
5-20	Release 2.1, Part Number 78-12510-02 Rev. C1, August 31, 2004

Image 20

Contents Configuring the MGX RPM-PR Accessing the RPM-PR Command Line InterfaceBooting the RPM-PR RPM-PR Bootflash Precautions Verifying the IOS Files on BootflashRouter#show bootflash Verifying the IOS Files on the PXM-45 x DriveAssigning an IP Address to the Switch Interface Initializing the RPM-PR CardEnter conf terminal to enter global configuration mode Routerconfig-if#ip address 1.1.1.1Router#show ip int brief Router#conf terminalBooting RPM-PR Using Tftp from a Tftp Server Configuring Ethernet Interfaces Preparing to Configure Ethernet InterfacesConfiguring IP Addresses and Starting Ethernet Interfaces Routerconfig#interface fastEthernet 1/1Router#configure terminal Back Card Bay and Interface Port NumbersRouter#show interface fastethernet 1/1 Routerconfig-if#ip address 172.29.54.166Router#config t Selecting the MII Receptacle for Ethernet Communications Save your configuration changesRouter#config terminal Enter the show interface command to check the configuration Selecting Media Type 100 for Fast Ethernet CommunicationsVerifying the Configuration Using the show Commands to Verify the New Interface StatusViewing the Hardware Configuration Routershow protocolsViewing the Boot Variable Using show Commands to Display Back Card InformationRouter#show bootvar Router#show versionVerifying Ethernet Connectivity Router#pingEstablishing 1N Redundancy Between Two or More RPM-PR Cards Slot number of the primary RPM-PR cardSlot number of the secondary RPM-PR card For 1n redundancyRPM-PR None Primary Slot Using Softswitch to Change the Active Card Deleting RedundancyAdding Additional Primary Cards Upgrading Redundant RPM-PR CardsContinue this procedure from for all remaining cards Upgrading Non-redundant RPM-PR Cards