Cisco Systems A9014CFD manual Configuring T1/E1 Controllers, Configuring the Card Type, 20-1

C H A P T E R 20

Configuring T1/E1 Controllers

This chapter provides information about configuring the T1/E1 controllers on Cisco ASR 901 router.

Contents

•Configuring the Card Type, page 20-1

•Configuring E1 Controllers, page 20-2

•Configuring T1 Controllers, page 20-4

•Troubleshooting Controllers, page 20-5

Configuring the Card Type

Perform a basic card type configuration by enabling the router, enabling an interface, and specifying the card type as described below. You might also need to enter other configuration commands, depending on the requirements for your system configuration and the protocols you plan to route on the interface.

	Note	In the following procedure, press the Return key after each step unless otherwise noted. At any time,
		you can exit the privileged level and return to the user level by entering disable at the Router# prompt.
		To select and configure a card type, complete the following steps:
	Command		Purpose
Step 1
	enable		Enables privileged EXEC mode.
			• Enter your password if prompted.
	Example:
	Router> enable
Step 2
	configure terminal		Enters global configuration mode.
	Example:
	Router# configure terminal

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		20-1