Mounting Sanding Disc
1.Remove Table (59) surrounding Sanding Disc (23).
2.Peel off old Sanding Disc.
3.Align perimeter of new Sanding Disc (23) over Aluminum Disc (22). When aligned, press disc firmly onto Disc.
Most Sanding Discs have
4.Replace Table (59).
Sanding Belt Replacement
1.Push the Belt Tension Lever (34) to the right to loosen the Belt (4).
2.Slide the old Sanding Belt (4) off the Idler Roller (41) and Drive Drum (5).
3.Slide the new Sanding Belt (4) onto the Idler Roller (41) and Drive Drum (5). Refer to the Parts List for correct Belt (4) replacement size.
4.Push the Belt Tension Lever (34) to the left to tighten the Belt (4).
5.Turn on the Belt Sander to test the new Belt. If the Belt tracks to one side, go to page 11 and follow the procedure for Belt Tracking Adjustment.
Troubleshooting
SYMPTOM | PROBABLE CAUSE | REMEDY |
Belt Sander does not | Not plugged in to electrical outlet | Connect to outlet |
turn on |
|
|
| Switch key not inserted into Switch | Insert Switch Key, then push |
|
| Switch to On position |
| GFCI or facility circuit breaker open | Reset circuit breakers |
| Power Switch defective | Replace Switch |
| Motor or wiring problem | Repair with a qualified technician |
Motor slows when | A qualified technician needs to | |
sanding |
| loosen tension |
| Sanding with too much pressure on | Apply less pressure when sanding |
| stock |
|
Sanding Belt runs off | Not tracking properly | Adjust Sanding Belt Tracking |
Idler Roller |
|
|
Wood burns while | Sanding Disc or Belt is loaded with | Clean or replace Disc or Belt. |
sanding | debris |
|
Sander makes exces- | A qualified technician needs to | |
sive noise |
| loosen |
SKU 93981 | For technical questions, please call | Page 13 |