To remove the disc, follow the installation procedure in reverse.
OPERATION
Sanding operation
15
008946
CAUTION:
•Always wear safety goggles or a face shield during operation.
•Never run the tool without the abrasive disc. You may seriously damage the pad.
•Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations.
Hold the tool firmly. Turn the tool on and then apply the abrasive disc to the workpiece.
In general, keep the abrasive disc at an angle of about 15 degrees to the workpiece surface. Apply slight pressure only. Excessive pressure will result in poor performance and premature wear to abrasive disc.
MAINTENANCE
CAUTION:
•Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or maintenance.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
•Plastic pad
•Abrasive discs
•Rubber pad (GV6010)
•Grip 36
7