| MODEL T21319 |
| 24" BENDING BRAKE |
| INSTRUCTION SHEET |
Introduction | Assembly |
The Model T21319 24" Bending Brake is ideal for a small workshop environment where ease of use is important. The Model T21319 can bend up to 18 gauge (0.473 in. or 12mm) mild steel.
To assemble your bending brake:
1.Securely mount the bending brake assembly to a workbench or other stable surface using 8mm hex bolts, flat washers, lock washers and hex nuts. Mounting hole locations are indicated in Figure 3.
Figure 1. Model T21319 24" Bending Brake.
Inventory (Figure 2) |
| |
A. | Bending Brake Assembly | 1 |
B. | Clamping Angle | 1 |
C. | Clamp Assemblies | 2 |
D. | Breaker Bar Levers | 2 |
E. Hardware Bag (not shown) |
| |
| — Hex Bolts | 4 |
| — Hex Nuts M10 | 4 |
| — Lock Washers 10mm | 4 |
|
| A |
|
| B |
|
| C |
| D |
|
| Figure 2. Inventory. |
|
Figure 3. Mounting hole locations (right side of
bending brake not shown).
2.Place the clamping angle on the bending brake assembly.
3.Mount each clamp assembly as shown in Figure 4 on the next page. Ensure that each adjustment set screw shown in Figure 4 is towards the outside of the bending brake assembly. Secure with hex bolts, lock wash- ers and hex nuts.
Copyright © MARCH, 2009 By Grizzly Industrial, Inc.
Warning: No portion of this manual may be reproduced in any shape Or form without the written approval of Grizzly Industrial, inc.
#Jb11595 printed in CHINA