Conveyor Belt
The conveyor belt tension and tracking adjust- ments are controlled by the adjustment bolts located at each end of the front and rear convey- or rollers. If the conveyor belt is too loose or tracks off to one side, adjust as follows:
1.If the conveyor belt is slipping, turn both infeed adjustment bolts
See Figure 16.
Roller Bracket
Allen® Head Screws
Roller Adjustment Bolt
Figure 16. Location of conveyor adjustments.
2.If the conveyor belt tracks toward the right side, turn the adjustment bolt located at the infeed right corner. Turning this bolt counter- clockwise will make the sanding belt move to the left.
3.After you have made the adjustment, run the machine for approximately 15 minutes to observe the tracking adjustment you made. Be patient, the belt tracks slow.
4.If the conveyor belt tracks too far to the left, loosen the adjustment bolt. Turning this bolt clockwise will move the sanding belt to the right.
Always make adjustments at the infeed end to avoid
G1066/G1066Z/G1079 Drum Sander |