Global Machinery Company SA186 instruction manual Selecting the right grade of sandpaper

Page 9

8.The paper should be kept tightly clamped over the base, otherwise there could be excessive wear of the base material.

WARNING. Never use the sander unless the entire base is fitted with sandpaper or another type of pad.

Selecting the right grade of sandpaper

WARNING. Always ensure that the tool is switched

off and the plug is removed from the power point before making any adjustments or maintenance procedures.

Different grades of sanding paper can be purchased from your local hardware store. Available grades are: Coarse, Medium and Fine.

Use a coarse grit to sand down rough finishes, medium grit to smooth the work and fine grit to finish off.

It is best to make a trial run on a scrap piece of material to determine the optimum grades of sandpaper for a particular job. If there are still marks on your work after sanding, try either going back to a coarser grade and sanding the marks out before recommencing with the original choice of grit, or try using a new piece of sandpaper to eliminate the unwanted marks before going on to a finer grit and finishing the job.

WARNING. Do not use the same sanding sheet for wood and metal. Metal particles become embedded in the sandpaper and will scour a wooden surface.

Dust extraction

WARNING. Always ensure that the tool is switched

off and the plug is removed from the power point before making any adjustments or maintenance procedures.

1.Attach the dust extraction canister (3) to the sander by pushing and twisting the bayonet fitting in a similar

action to inserting a light globe into a lamp.

WARNING. For optimum dust extraction, remove and empty the canister (3) when it is no more than half full. Do not use the canister when sanding metal. The hot metal particles could cause residual wood dust or the internal bag itself to catch fire.

2.Remove the cap from the end of the canister (3) to access the internal bag when you wish to replace or clean the bag. The bag can be washed. Make sure the bag is completely dry before replacing it.

Maintenance

WARNING. Always ensure that the tool is switched

off and the plug is removed from the power point before making any adjustments or maintenance procedures.

1.Keep the tool’s air vents unclogged and clean at all times.

2.Regularly check to see if any dust or foreign matter has entered the grills near the motor and around the on/off switch. Use a soft brush to remove any accumulated dust. Wear safety glasses to protect your eyes whilst cleaning.

3.If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used but nothing like alcohol, petrol or other cleaning agent.

4.Never use caustic agents to clean plastic parts.

CAUTION. Water must never come into contact with the tool.

5. Lubricate all moving parts at regular intervals.

9

Image 9
Contents Sheet Orbital Sander Contents Specifications Description of symbolsElectrical safety Safety instructionsService Additional safety rules for sandersAccessories Know your product Switching on and off Using the sanderFitting a sanding sheet Selecting the right grade of sandpaper General Inspection Power cord maintenanceSave this Manual for future reference