Note. After sanding with a belt sander, an orbital sander should be used to give a finer surface finish.
Sanding
WARNING. The sander is designed for most sanding operations but it is not to be used as a wet sander.
The sander is designed for sanding wood, plastic and similar materials. It is used mainly for quickly removing a large amount of material. Do not use this sander for sanding magnesium.
1.Ensure that the belt is in good condition.
2.Plug the tool into a power socket.
3.Bring down the sander onto the work piece and apply light pressure. Do not apply too much pressure on the palm belt sander. Pushing down too hard on the belt sander may cause damage or reduce the life of the product
4.Press the “I” switch (1) and
allow the belt to reach full speed before moving it across the work.
5.To remove paint or smooth very rough wood, sand across the grain at 45o in two directions, and then finish parallel with the grain.
6.Bring down the sander onto the workpiece and apply light pressure. For best results use
the sander in a linear motion not circular.
Using the sander in a circular motion may result in the belt tracking slipping.
WARNING. Do not apply too much pressure on the palm belt sander. Pushing down too hard on the belt sander may cause damage or reduce the life of the product. The product is designed for one handed operation applying light pressure.
7.Use the front roller (8) only to sand corners or
irregular shapes.
8.Lift the sander off the work before switching off.
9.Remember to keep your hands away from the moving belt, as it will continue to move for a short time after the machine is switched off.
10.Wear safety goggles, a dust mask and ear defenders.
Dust extraction
1.Disconnect the plug from the power supply
2.A vacuum cleaner adaptor can be used to connect a household vacuum cleaner or workshop dust extraction system to the sander. The adaptor fits into the dust extraction port (5).
As the unit has no
WARNING. Never use a dust extraction device when sanding metal. The hot metal particles may cause wood dust or the bag itself to catch on fire.
General inspection
•Regularly check that all the fixing screws are tight. They may vibrate loose over time.
•The supply cord of the tool and any extension cord used should be checked frequently for damage. It damaged, have the cordset replaced by an authorised service facility. Replace the extension cord if necessary.
9