Global Machinery Company KAT150A instruction manual Additional safety rules for sanders

Page 5

or replaced by an authorised service facility, unless otherwise indicated in this Instruction Manual. Defective switches must be replaced by an authorised service facility. Do not use a tool if the switch does not turn the tool on and off correctly.

19.Guard against electric shock. Prevent body contact with grounded objects such as water pipes, radiators, cookers and refrigerator enclosures.

20.Use only approved parts. When servicing, use only identical replacement parts. Use an authorised service facility to fit replacement parts.

Warning. The use of an accessory or attachment, other than those recommended in this Instruction Manual, may present a risk of personal injury.

Additional safety rules for sanders.

Warning. Remove the plug from the power socket before carrying out any adjustment, servicing or maintenance, including the changing of sandpaper.

When fitting and changing sandpaper, always follow the instructions.

If possible, always use clamps or a vice to hold your work.

Make sure that the switch is off before you plug the tool in.

Do not over-reach, be sure of your footing and balance at all times.

Always wear eye and ear protection and use a dust mask.

Only use good quality sandpaper.

Do not force the sander; let the tool do the work at a reasonable feed speed. Overloading will occur if too much pressure is applied and the motor slows resulting in inefficient sanding and possible damage to the sander motor.

Always switch off before you put the sander down.

Disconnect the sander from the power supply when it is not in use, before cleaning and when changing

sandpaper.

Rags, cloths, cord, string and the like should never be left around the work area.

Do not continue to use worn, torn or heavily clogged sanding sheets.

Do not touch the moving sanding sheet.

Ensure that you have removed foreign objects such as nails and screrws from the work before commencing sanding.

WARNING. Before connecting a tool to a power source (mains switch power point receptacle, outlet, etc.) be sure that the voltage supply is the same as that specified on the nameplate of the tool. A power source with a voltage greater than that specified for the tool can result in serious injury to the user, as well as damage to the tool. If in doubt, do not plug in the tool. Using a power source with a voltage less than the nameplate rating is harmful to the motor.

The tool must be used only for its prescribed purpose. Any use other than those mentioned in this Manual will be considered a case of misuse. The user and not the manufacturer shall be liable for any damage or injury resulting from such cases of misuse.

To use this tool properly, you must observe the safety regulations, the assembly instructions and the operating instructions to be found in this Manual. All persons who use and service the machine have to be acquainted with this Manual and must be informed about its potential hazards. Children and infirm people must not use this tool. Children should be supervised at all times if they are in the area in which the tool is being used. It is also imperative that you observe the accident prevention regulations in force in your area. The same applies for general rules of occupational health and safety.

The manufacturer shall not be liable for any changes made to the tool nor for any damage resulting from such changes.

Even when the tool is used as prescribed it is not possible to

5

Image 5
Contents 125W Detail Sander Contents Specifications SymbolsDear Customer IntroductionGeneral safety instructions Only use good quality sandpaper Additional safety rules for sandersAccessories Unpacking AssemblyKnow your product Sanding OperationFitting sandpaper Maintenance CleaningPower cord maintenance General inspectionSave this Manual for future reference