5.Mount the motor to the motor mount. Leave the bolts finger tight for now.
6.Lift the spring loaded side of the jackshaft assembly up and insert a 1⁄16'' shim between the cast bearing block and the aluminum pad.
7.Lift the motor up and slip the two flat bars between the stand top and the motor drive disc. Let the weight of the motor rest on the flat bars. Tighten down the motor mount bolts.
8.Remove the two flat bars and the shim fromthe jack shaft assembly.
9.Align the center of the motor drive disc to the centerline of the jack shaft. Figure 5. Tighten the motor mount bolts.
Drive disc
Jackshaft
C/L 
Align the center of the drive disc to the centerline of the jack shaft
Figure 5.
10.
Wiring The Motor
1.Remove the wire box cover.
2.Feed the power source wires from the switch into the motor junction box.
3.Wire the motor per the diagram in Figure 6. The wires from the power supply, besides the Green Ground wire, are interchangable, therefore colors are not specified.
4.The green wire from the cord is grounded to the motor casing.
5.
Note: To reverse rotation, switch the positions of motor wires #5 and #6.
Figure 6.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
G5049Z Combination Sander | ||||||