Harbor Freight Tools 91773 Work Piece and Work Area Set Up, General Operating Instructions

Page 11

make sure the sandpaper is taut. Hold in place with the screwdriver and lower the tension bar.

To remove the sandpaper, pull up on the tension bar at each end of the Inline Sander and pull out the sandpaper.

Work Piece and Work Area Set Up

1.Designate a work area that is clean and well-lit. The work area must not allow access by children or pets to prevent distraction and injury.

2.Route the air hose along a safe path to reach the work area without creating a tripping hazard or exposing the air hose to possible damage. The air hose must be long enough to reach the work area with enough extra length to allow free movement while working.

3.Secure loose workpieces using a vise or clamps (not included) to prevent movement while working.

4.There must not be hazardous objects (such as utility lines or foreign objects) nearby that will present a hazard while working.

General Operating Instructions

1.Identify the area you will be sanding. Make sure you are using the appropriate grit sandpaper for the job. Clear any objects from the area you will be sanding.

2.Install a sheet of sandpaper onto the Sander

3.Connect the Sander to the air compressor’s hose. If leaking is detected, disconnect the air hose and repair before use.

4.Firmly grip the Handle (27) with one hand and the Knob (22) your other hand.

5.Depress the Trigger (26) before making contact with the work surface to ensure the Inline Sander does not jump from your hands.

6.Move the Inline Sander along the work surface in a smooth steady motion. Do not stay in any one area for more than a few seconds at a time. Sand in random directions to avoid sanding a pattern into your work surface.

7.Do not put too much pressure on the Inline Sander while you are sanding. Let the weight of the tool do the work for you. If the Inline Sander stalls while you are using it, release the Trigger immediately.

8.If the tool requires more force to accomplish the task, verify that the tool receives sufficient, unobstructed airflow (CFM) and increase the pressure

(PSI) output of the regulator up to the maximum air pressure rating of this tool (90 PSI).

CAUTION! To prevent tool and accessory failure, resulting in injury:

Do not exceed the tool’s maximum air pressure rating.

9.To prevent accidents, turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and release the throttle and/or turn the switch to its off position after use. Clean external surfaces of the tool with clean, dry cloth, and apply a thin coat of tool oil. Then store the tool indoors out of children’s reach.

REV 10f

 

 

SKU 91773

For technical questions, please call 1-800-444-3353.

Page 11

Image 11
Contents 4 x 17-1/2 Air Inline Sander For technical questions or replacement parts, please callContents General Safety Alert Symbol and Signal WordsPersonal safety Save This ManualTool use and care Min ServiceSpecific Safety Instructions Air sourceVibration Precautions For technical questions, please call Functional Description Nitial Tool Set UpAssembly Injury from accidental operation Ball valve because it can be closed quicklyOperating Instructions Tool Set UpInstalling Sandpaper SKU For technical questions, please call Work Piece and Work Area Set UpGeneral Operating Instructions Do not exceed the tool’s maximum air pressure ratingCleaning, Maintenance, Lubrication User-Maintenance InstructionsPlease Read the Following Carefully TroubleshootingProblem Possible Causes Likely Solutions Qty Parts list and Assembly DiagramPart Description Qty Part DescriptionRecord Product’s Serial Number Here Limited 1 Year warranty