Removing / Attaching Battery Pack

RELEASE

BUTTON

Do not use charger if it has been damaged, left outdoors in the rain, snow, wet or damp environments, or immersed in liquid.

The battery pack and charger heat during charging. Place the charger on a flat, non-flammable surface away from flammable materials with at least four inches of clearance to allow proper air circulation around the charger and battery pack.

When the battery pack requires recharging, a 3-5 hours charge allows the tool to operate at full power. A charging indicator light on the charger will illuminate to show that charging is taking place.

CHARGING BATTERY PACK USING CHARGER #690072 / ADAPTER #690074

REMOVE BATTERY PACK:

1.Press both release buttons on either side of the Cordless Waxer/Polisher to release the battery pack.

2.Pull battery pack free of Cordless Waxer/Polisher.

ATTACH BATTERY PACK:

1.Align the raised portion of the battery pack with the groove in the battery compartment of the Cordless Waxer/Polisher.

2.Press the battery pack into place. Make sure the latches are securely fastened. Do not use the Cordless Waxer/Polisher if the battery pack is not seated properly.

CHARGER #690072 / ADAPTER #690074

CHARGE BATTERY PACK:

1. Make sure the trigger on the Cordless Waxer/Polisher is in the “OFF” position and remove the battery pack from the Cordless Waxer/Polisher.

2. Insert the battery pack into the charger. Be sure that the battery pack is fully seated in the charger. Do not force.

3.Plug the charger into the nearest 120 volt, electrical

outlet. The indicator light will come “ON”.

BATTERY PACK

120V AC

ADAPTER

LED LIGHT

BATTERY

CHARGER

Before using battery charger, please read carefully all instructions and cautionary markings on battery charger, battery pack and product using battery.

The charger will not automatically turn “OFF” when the battery pack is fully charged. The charging indicator light will remain “ON” until the charger is disconnected from the electrical outlet. To prolong battery life, REMOVE battery from charger after 3-5 hours of recharging.

Use only the charger which accompanied your product or direct replacement as listed in this manual. Do not substitute any other charger. Use only Alltrade approved chargers with your product.

Do not disassemble charger.

IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES

When using your Cordless Waxer/Polisher continuously, the batteries in your bat- tery pack will become hot. You should let a hot battery pack cool down for approx- imately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, the red light on the charger will flash. When the battery pack cools down, the red light will glow continuously.

This will occur when continuous use of your Cordless Waxer/Polisher causes the battery pack to become hot. It does not occur

under normal circumstances.