0 Dust bag attachment
To install the dust bag, fit the bag's entry port onto the dust chute on the right side of the sander, then see that the small hole on the port fits over the pin protruding from the chute by turning left or right.
When removing the dust bag, turn the bag to the left t o slip the hole off the pin, then simply pull off the dust bag.
Removing the frame cover
Remove from either the front or back as shown, when taking off the frame cover.
0 Regular emptying of dust bag
Regular emptying of the dust bag insures the maximum suction force. A full bag makes for ineffectivedust collection.
0 Operation with coolant
This tool can be used to sand with waterproof paper and a coolant, but coolant should never be allowed to enter the motor area. To use coolant, first remove the dust bag and clean off any dust adhering to the tool. Do a dry run for 2 or 3 minutes with the tool held off the surface in order to remove dust adhering to the dust chute area. Then use only enough coolant to give good operation as excessive coolant can easily be splashed into the motor and markedly shorten motor life. Coolant may also bridge parts which could result in a shock hazard.
commercial abrasive paper of the size |
|
|
|
|
| |
228 mm (9") x 280 mm | may |
|
|
|
|
|
be used by cutting it in half. | . . | . | . | . | ||
| . . - | . | - |
|
| |
|
| .. . . .. |
|
| ||
| :. | , | ||||
|
|
| _ . |
| . . | |
|
|
|
| . . . . . |
| |
' 2 8 0 mm (
4