TOADJUSTSANDINGBELTTRACKING
See Figures 5 and 6.
Belt life is greatly increased if you regularly adjust the sanding belt tracking. When correctly adjusted, the outer edge of the sanding belt should be even with the outer edge of the base of the sander.
When you install a new sanding belt, you may need to adjust the sanding belt tracking several times until the belt becomes pliable.
Follow these steps to adjust sanding belt tracking.
_IL WARNING: Before connecting the sander to a power supply, always make sure it is not in the
•Connect the sander to a power supply.
•Position the sander upside down with the cord on the left.
Note: This position is for adjustments only. The sanding belt should not contact a workpiece or any foreign object when you are making belt tracking adjustments.
Fig. 5
Depress the trigger switch and release immediately.
Choose one of these options:
•Sanding belt runs inward: Turn the tracking knob slowly clockwise.
•Sanding belt runs outward: Turn the tracking knob slowly counterclockwise.
Note: Turn the tracking knob until you are sure the sanding belt is secure, i.e., it will not come off the sander or contact internal parts.
A CAUTION: If the sanding belt wears excessively on the inner edge, it is probably adjusted too far inward and is rubbing against internal parts. If this is the case, readjust the tracking knob.
•Start the sander and fine adjust the tracking knob until the belt stabilizes.
,a, WARNING: Keep hands and fingers away from a moving sanding belt. Any part of the body coming in contact with a moving sanding belt could result in serious injury. Do not wear loose clothing or jewelry when operating the sander. They could get caught in moving parts and foreign objects could get thrown away from the sander causing injury.
CLOCKWISEIFBELT
RUNSINWARD \\_\ | _ I I \\ _._J |
TURN
COUNTERCLOCKWISEIF
BELTRUNSOUTWARD | Fig. 6 |
11