Desa 33014, 33015 operating instructions Product Overview, Operating Tool

18.Hot melt glue is not resistant to flammable liquids. Do not use to repair fuel tanks.

19.Do not attempt to repair tool or replace broken parts. Any servicing should be done by factory service center.

Keep these operating instructions for reference. It is your guide to safe and proper operation of this tool.

Product Overview

The HandyMaster Hot Melt Glue Gun is a multi-purpose tool. This tool is designed for home and workshop. It performs basic fastening jobs from creating crafts and decorations to repairing shoes and furniture. The model 33014 glue gun uses mini-sized glue sticks. The model 33015 glue gun uses standard sized glue sticks.

Operating Tool

!WARNING

Do not touch melted glue or hot tool nozzle. Temperature of nozzle reaches 380°F (193°C). Severe burns will occur.

1.Attach wire stand to tool. Snap open ends of stand into holes near nose of tool. Use stand when setting hot tool down. This allows good ventilation for the tool. Do not lay hot tool on its side.

2.Plug power cord into a standard outlet. Use extension cord if needed.

3.Insert glue stick into rear opening of tool.

4.Let tool heat for three to five minutes before using.

5.Squeeze trigger to apply glue.

Note: The amount of glue released depends upon how far you squeeze trigger.

6.Unplug tool when finished or if not planning to use tool within two hours.

7.Do not remove glue stick from tool. This may damage tool. Melted glue inside tool will cool and can be stored this way. This glue will remelt when using tool next time.

8.Allow tool to cool at least 15 minutes before storing.

3