Parkside PHKP 500SE manual Operation / Maintenance and Cleaning / Service / Warranty

Page 8

Operation / Maintenance and Cleaning / Service / Warranty

Gluing:

Press the feed clamp 5 to regulate the flow of glue as required for your work.

1.Apply the glue in individual dots. Apply in zig- zags on flexible materials such as fabrics.

2.Immediately after applying the glue, press the two materials together for about 30 seconds. The glued joint can be loaded after about 5 minutes.

3.When you take a break from work, set the glue gun down on the wire stand 6 or in the charger 4 .

4.Remove any glue residue with a sharp knife after cooling. Glued joints can be loosened again by applying heat.

Switching off the device:

Pull the mains lead out of the mains socket.

Changing the nozzle:

Wear protective gloves.

Heat up the device for about 4 minutes. Change the nozzle 8 when it is hot.

DANGER OF BURNS! Touch the nozzle 8 only by the heat shield 9 . The nozzle tip is hot!

Maintenance and Cleaning

The glue gun is maintenance-free.

WARNING! Pull the mains lead out of the mains socket before you clean the tool. Always keep the device clean and dry.

Do not allow any liquids to enter the tool. Use a soft cloth to clean the housing. Never use petrol, solvents or cleaning agents that might attack plastic.

Service

WARNING! Have your device repaired only by qualified specialist personnel using original manufacturer

parts only. This will ensure that your device remains safe to use.

WARNING! If the plug or mains lead needs to be replaced, always have the replacement carried out by the manufacturer or its service centre. This will ensure that your device remains safe to use.

Warranty

This appliance is guaranteed for 3 years from the date of purchase. It has been care- fully produced and meti-culously checked before delivery. Please keep your receipt as proof of purchase. Contact your service centre by telephone in case of questions pertaining to the warranty. Your goods can be transmitted free of cost only in this manner. This warranty applies only to the initial purchaser and is non-transferable.

The warranty covers only material or manufacturing faults, not normal wear or damage to fragile parts such as switches or rechargeable batteries. The appli- ance is intended solely for private, not commercial, use.

If this product has been subjected to improper or inappropriate handling, abuse, or interventions not carried out by one of our authorised sales and service outlets, the warranty will be considered void. This warranty does not affect your statutory rights.

GB

DES UK LTD

Tel.: 0871 5000 700 (£ 0,10 / minute)

e-mail: support.uk@kompernass.com

IE

Kompernaß Service Ireland

Tel.: 1850 930 412 (0,082 €/Min.) * Standard call rates apply.

Mobile operators may vary. e-mail: support.ie@kompernass.com

GB/IE/CY 9

Image 8
Contents Phkp 500 SE Page Page Table of contents Features IntroductionHot glue gun Phkp 500 SE Introduction Proper useIntroduction / Safety notes Workplace safetyElectrical safety Personal safetySafety notes / Operation Careful handling and use of electrical power toolsBefore first use Preparing the tool for useOperation / Maintenance and Cleaning / Service / Warranty Maintenance and CleaningService WarrantyBochum Hans Kompernaß Managing Director Disposal / Declaration of Conformity / ManufacturerDisposal Kompernass Gmbh