Installing or removing the battery cartridge |
|
| |
Always switch off the tool before insertion |
| Battery cartridge | |
or removal of the battery cartridge. |
| ||
|
| ||
To remove the battery cartridge, pull out the |
|
| |
set plate on the tool and grasp both sides |
|
| |
of the cartridge while withdrawing it from |
|
| |
the tool. |
|
| |
To insert the battery cartridge, align the |
|
| |
tongue on the battery cartridge with the |
|
| |
groove in the housing and slip it into place. | I ’ |
| |
Snap the set plate back into place. Be sure | Set plate | ||
to close the set plate fully before using the | |||
| |||
tool. |
|
Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly.
Charging
Plug the fast charger into your power source. Insert the battery cartridge so that the plus
and minus terminals on the battery cartridge Charging light are on the same sides as their respective
markings on the fast charger. Insert the Start buttonReset button cartridge fully into the port so that it rests
on the charger port floor. Press the start button (red). The charging light will come on and charging will begin. If the charging light does not come on, press the reset button (yellow) first, then the start button (red). If the charging light goes out within 10 seconds even after pressing the reset button
and start button a couple of times, the battery cartridge is dead. (CAUTION: Wait for more than 5 seconds after the charging light goes out to press the reset button again.) Replace it with a new one. When the charging light goes out in a certain time, you may remove the fully charged battery cartridge. Refer to the table below for the charging time.
Fast charger | DC9700 | DC1201 | DC9015 | DC9112 | |
Battery cartridge | |||||
|
|
|
| ||
9100, 9100A | Approx. 60 min. | Approx. 45 min. | Approx. 15 min. | Approx. 60 min. | |
9101, 9101A | ~~ | Approx. 60 min. | - | - |
7