Hints for use
•When driving screws close to the ends of hardwoood or treated timber boards it may be necessary to
•Use the proper screws for the task on hand. Drywall screws are not suitable for decking applications.
•Make sure that screws are long enough to ensure a secure fastening.
•Use the low speed gear when driving into decking and the like, and the high speed gear when driving into drywalls.
•Once the screw has started to drive into the material, do not stop until it is fully seated. Keep full pressure of the bit on the screw head to prevent slippage and possible damage to the screw head or bit.
•Before driving deck screws check that there is not gap between the board and the support.
•Do not drive through knots in the wood unless absolutely necessary. If there is no choice,
Maintenance
WARNING. Ensure that the tool is switched off and the battery is removed before changing accessories or carrying out other adjustment or maintenance procedures.
Keep the tool’s air vents unclogged and clean at all times.
Regularly check to see if any dust or foreign matter has entered the grills near the motor and around the trigger switch. Use a soft brush to remove any accumulated dust. Wear safety glasses to protect your eyes whilst cleaning.
If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used but nothing like alcohol, petrol or other cleaning agent.
Never use caustic agents to clean plastic parts.
CAUTION. Water must never come into contact with the tool.
General inspection
Regularly check that all the fixing screws are tight. They may vibrate loose over time.
14