2. With the pendulum control (2) set at position , the blade swings up and down as well as moving backwards and forwards. This “pendulum action cutting” is very efficient when cutting softer materials.
Note. Pendulum action cutting can leave a rough finish.
Use a file or rasp to clean up the cut edge if necessary.
WARNING. Use the straight cutting mode when you wish to make curved or clean cuts, even when working with soft materials.
Changing the position of the shoe
CAUTION. Always ensure that the saw is switched off and unplugged from the power supply.
1.Loosen the two shoe adjustment screws (10) with hex key (11) and position the shoe to shield the length of saw blade as required.
2.
CAUTION. Do not operate the reciprocating saw if the adjustable shoe is damaged or not installed.
Rotating the rear handle
CAUTION. Always ensure that the saw is switched off and unplugged from the power supply.
1.The rear handle (7) can be rotated in a circle to eight set positions of operation, spaced 45° apart.
2.The rear handle must be “locked” into one of the eight preset positions. It must not be used at any position in between these eight preset positions as it might rotate during use and create a hazard.
3.To rotate the handle (7) press on the handle rotation release switch (8) and move the handle to one of the present positions. It can be turned three positions to the left and four positions to the right.
3.Position the angle of the shoe as required by pivoting it on its axis.
4.Where possible, rest the shoe on the material being cut. Change the angle of the shoe to suit the shape of the material.
General cutting
1.Hold the saw firmly in front and clearly away from you.
2.Make sure that the blade is clear of any obstruction and that the power cord or any extension cord is out of the path of the blade.
3.Ensure that the material to be cut is held firmly. Small workpieces should be held in a vice or clamped to the workbench.
9