CONTROL FEATURES:
DEPTH
ADJUSTMENT KNOB This knob controls the
depth of your cut.
BLADE SAFETY
LOCK BUTTON
This button locks the blade in position and prevents it from moving.
HANDLE ADJUSTMENT
1. Unplug the power cord. Release the handle adjustment lock by pushing the plastic slide in the direction as shown by the arrows on the adjustment lock to disen- gage from the locking pin.
2. Then pull the adjustment lock down so that it is in parallel with the motor. Now, raise or lower the handle as desired.
3. Once in the desired position, raise and 
push the adjustment lock back to the 
handle and ensure it locks inside the pin. 
ASSEMBLY
Always make sure that the power cord is unplugged and the trigger switch is “OFF” before changing blades or attachments.
When removing the blade from the tool, avoid contact with skin and use proper protective gloves when grasping the blade or accessory. Accessories
may be hot after prolonged use.
If the blade clamp screw will not loosen enough to allow blade installation, tap gently on the end of the wrench with a mallet until the clamp screw breaks free.
ATTACHING AUXILIARY HANDLE
This tool comes with an auxiliary handle which can be attached to the side of the circular saw. This handle is necessary to maintain complete control of the tool and should be used at all times. Make sure this handle is always fastened securely.
ATTACHING / REMOVING BLADE
Always UNPLUG the power cord before installing or removing blade.
When removing the blade from the tool, avoid contact with skin and use proper protective gloves when grasping the blade or accessory. Accessories may be hot after prolonged use.
RIP FENCE
The scaled rip fence guides the saw to cut exactly along the edge of work piece, making straight and
accurate parallel cuts.
11
RIP FENCE LOCK KNOB This knob secures the rip fence in place.
12