Ryobi RJC180 specifications Plunge Cutting, Metal Cutting

Page 11

OPERATION

PLUNGE CUTTING

See Figure 9.

Fig. 9

Mark the line of cut clearly. Choose a convenient starting point inside the area to be cut out and place the tip of the blade over that point. Rest front edge of base (shoe) assembly on work and hold firmly in position. Depress the lock-off button, then pull switch trigger to start the cutting action.

WARNING:

Make sure blade does not touch work until motor reaches full speed, since this could cause loss of control resulting in serious injury.

With saw blade at full cutting speed, slowly tilt saw downward until tip of blade starts cutting work. After blade penetrates work, tilt saw until blade is perpendicular to the work.

METAL CUTTING

See Figure 10.

Fig. 10

Metals such as sheet steel, pipe, steel rods, aluminum, brass, and copper may be cut with your saw. Be careful not to twist or bend the saw blade. Do not force. We recommend cutting oil when cutting most soft metals and steel. Cutting oil will also keep blades cool, increase cutting action, and prolong blade life.

Never use gasoline since normal sparking of motor could ignite fumes. Clamp the work firmly and cut close to the clamping point to eliminate any vibration of the work being cut. When cutting conduit pipe or angle iron, clamp work in a vise if possible and cut close to the vise. To cut thin sheet material, "sandwich" the material between hardboard or plywood and clamp the layers to eliminate vibration and material tearing.

Page 11

Image 11
Contents Thank YOU for Buying a Ryobi Cordless Reciprocating SAW SpecificationsTable of Contents Specific Safety Rules AND/OR Symbols General Safety RulesImportant Safety Instructions For Charger Symbol Name DESIGNATION/EXPLANATION SymbolsSymbol Meaning Safety Alert Symbol Features Blade Wrench 5 mm HEX KEY To Install SAW Blade AssemblyTo Remove / Attach Battery Pack Operation Pivot Base Shoe AssemblyTo Change Positions of Base Shoe Assembly General CuttingMetal Cutting Plunge CuttingCYC MaintenanceBattery Pack Removal and Preparation for Recycling BatteriesPage Service Model NO. and Serial no