CHARGINGTHE BATTERY
Note: Always switch to a fresh battery when tool performance begins to diminish. Severe heat is most destructive to a battery; the more heat generated, the faster the battery loses power. A battery that gets too hot can be permanently damaged. Never
1.When a Battery (47) requires recharging, a 3 to 5 hour* charge allows the tool to operate at full power. Do not recharge the Battery longer than 5 hours*, as damage to the Battery and/or tool will occur.
2.To charge the Battery (47), plug the AC Charger Adapter’s (53) plug into the Charger (52). Insert the Charger (52) onto the top of the Battery (47) until it locks into place. Charging room temperature: 50° F - 104° F. Then, plug the AC Charger Adapter into the nearest 120 Volt, grounded, electrical outlet. (See illustration below.)
3.Two Charging Indicator LEDs on the Charger (52) will illuminate to show that charging is taking place. NOTE: The AC Charger Adapter (53) will not automatically turn off when the Battery is fully charged, and the Charging Indicator LEDs will remain on until the AC Charger Adapter is disconnected from the electrical outlet. Recharging the Battery more than 5 hours* can cause damage to the battery cells.
4.While charging, the Battery (47), AC Charger Adapter (53), and/or Charger (52) may become warm to the touch. This is normal, and does not indicate a problem.
5.Once the Battery (47) is fully charged, disconnect the AC Charger Adapter (53) from the electrical outlet. Then, disconnect the Charger from the Battery.
*The Battery (47) require an initial charge time of 8 hours. Do not recharge the Battery more than 5 hours after this initial charging.
SKU 93830 | For technical questions, please call | Page 10 |