Hilti WSR1000 operating instructions Preparation for use, Operation, Sawing

Failure to observe this point may result in damage to the tool or present a risk of accident. Accordingly, if neces- sary, have the tool repaired at a Hilti service centre or authorised Hilti repair workshop.

12. Always wear protective gloves and suitable protective goggles when working as saw blades may break or splinter.

Use clamps or a vice to hold the work. It is safer than using your hand and it frees both hands to operate the tool.

Form the habit of checking to see that keys and adjust- ing wrenches are removed from the tool before switching it on.

c)Turn the blade clamp locking sleeve in a counter- clockwise direction. Insert the blade in the blade clamp and press in the locking sleeve. Release the locking sleeve until it is heard to engage. Check that it is held

securely by pulling on the blade .

Note: If the saw blade cannot be inserted into the blade clamp, turn the locking sleeve a little until the blade is in the correct clamping position and then release the locking sleeve.

Removing the insert tool

a)Unplug the supply cord from the electrical sock-

et to prevent unintentional starting.

b) Turn the locking sleeve and pull out the blade . Wear protective gloves. The insert tool may be very hot after long periods of use.

Preparation for use

It is essential that the safety precautions print- ed in these operating instructions are read and observed.

The supply voltage must correspond to the infor- mation on the type plate.

If extension cords are used: Only extension cords of a type approved for the intended use and of ade- quate cross section may be used. Failure to observe this point may result in reduced performance of the tool and overheating of the cord. Damaged extension cords must be replaced. The recommended cross-sections and max.

length for extension cords are:

	Conductor cross-section
Mains voltage	1.5 mm2	2.5 mm2
100 V	20 m	40 m
230 V	50 m	100 m

Extension cables outdoors

Only suitable approved and correspondingly marked cables may be used outdoors.

Always stay alert

Always concentrate on your work. Proceed logically and do not use the tool when your full concentration is not on the job.

Operation

Inserting the blade

Use only blades with a standard 1/2″ shank connection end.

a)Unplug the supply cord from the mains socket to prevent unintentional starting.

b)Check that the connection end of the blade is clean. Always ensure that the blade clamping mechanism is kept clean.

Sawing

Setting the stroke rate

The recommended stroke rate can be pre-selected by turning the stroke rate adjusting wheel to the desired setting. When the operating switch is pressed the saw will then run at the pre-selected stroke rate. The recom- mended stroke rate settings and information concern- ing the correct choice of saw blade can be found in the information supplied with these products and in the cor- responding table of applications.

Stroke rate selection

(1 = low stroke rate, 4 = high stroke rate)

Material cut	Recommended stroke rate
Wood	4
Wood with embedded nails	4
Drywall, interior finishing	3
Plastic	1–3
Steel	1–3
Non-ferrous metals	2–3
Aluminium	2–3
Stainless steel	1

The above settings are recommendations intended to ensure optimum cutting performance. The optimum set- ting may differ from these recommendations depending on the saw blade used, the mains supply voltage and the sawing technique employed. Use of the wrong stroke rate setting may result in increased saw blade wear.

Adjusting the contact shoe

Unplug the supply cord from the mains socket in order to prevent unintentional starting. Adjustment of the shoe does not require the use of tools and is thus quick and convenient . Correct adjustment of the contact shoe ensures that the full length of the saw blade can be used optimally and may also improve access in corners.

10