Installing or removing the battery cartridge
0 Always switch off the tool before insertion or removal of the battery cartridge.
0 To remove the battery cartridge, pull out the set plate on the tool and grasp both
sides of the cartridge while withdrawing itBattery cartridge from the tool.
To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Snap the set plate back into place. Be sure to close the set plate fully before using the tool.
Fig.
Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being inserted correctly.
Charging
Your new battery cartridge is not charged. You will need to charge it before use. Use the fast charger Model DC1201 to charge the battery cartridge.
*Plug the fast charger into the proper A/C voltage source. The charging light will flash in green color.
Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their
respective markings on the fast charger.Fig. Insert the cartridge fully into the port so that it rests on the charger port floor.
When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The charging light will remain lit steadily during charging.
*When charging is completed, the charging light color will change from red to green and a tone will sound steadily for about 5 seconds.
After charging, unplug the charger from the power source. Refer to the table below for the charging time.
I
I
Fast charger
1200
1201 / 1201A
I I
DC1201
Approx. 45 min ADDrOX. 60 min
9