quickly in green color.
5.When in any of the conditions that bat- tery pack is too cool, or the battery pack has not been used for a long time, the charging lamp is lit.
In this case, charging takes longer to fully charge the battery pack, than the standard charging time.
If a fully charged battery pack is inserted into the charger again, the charging lamp light up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed.
6.If the charging lamp does not light immediately after the charger is plugged in, or if after the standard charging time the lamp does not go off, consult an authorized dealer.
NOTE:
When charging a cool battery pack (below 5°C (41°F)) in a warm place,
leave the battery pack at the place and wait for more than one hour to warm up the battery to the level of the ambient temperature. Other- wise battery pack may not be fully charged.
Cool down the charger when charging more than two battery packs consecutively.
Do not insert your fingers into con- tact hole, when holding charger or any other occasions.
CAUTION:
•Do not use power source from an engine generator.
This can damage the charger and present the risk of fire or personal injury.
•Do not cover vent holes on the charger and the battery pack..
. LAMP INDICATIONS
Red Flashing
Red Lit
Green Flashing quickly
Orange Lit
Orange Flashing
Charger is plugged into the AC outlet. Ready to charge.
Now charging
Charging is completed.
Battery pack is warm. Charging will begin when temperature of battery pack drops.
Charging is not possible. Clogged with dust or malfunction of the battery pack.
. MAINTENANCE
CAUTION: Always be sure that the tool is switched off and the battery pack is removed before attempting to perform inspection or maintenance.
Keep your Reciprocating saw clean for good cutting performance and to help keep it safe to use.
Wipe the reciprocating saw with a dry, soft cloth. Do not use a wet cloth or cleaning liq- uids. They could damage the reciprocating saw’s finish.
Be sure to rub off any oil or grease which could make the tool slippery or hard to handle.
BATTERY RECYCLING
ATTENTION:
FOR Ni-MH Battery Pack, EY9251
A nickel metal hydride battery that is recyclable powers the product you have pur- chased.
- 10 -