Ryobi R10631 specifications To Help Maintain Control

Page 14

OPERATION

TO HELP MAINTAIN CONTROL:

Always support your workpiece near the cut.

Support your workpiece so the cut will be on your left.

Clamp your workpiece so it will not move during the cut.

Place your workpiece with its good side down.

NOTE: The good side is the side on which appearance is important.

Before beginning a cut, draw a guideline along the desired line of cut. Then place front edge of base on that part of your workpiece that is solidly supported. See Figure 13.

Never place your saw on that part of the workpiece that will fall off when the cut is made. See Figure 15.

Hold your saw firmly with both hands.

See Figure 16.

Depress the lock-off button and squeeze the switch trigger to start your saw. Always let the blade reach full speed, then guide your saw into the workpiece.

WARNING:

The blade coming in contact with the workpiece before it reaches full speed could cause your saw to "kickback" towards you resulting in serious injury.

When making a cut use steady, even pressure. Forcing causes rough cuts, could shorten the life of your saw and could cause "kickback."

DANGER:

When sawing through work, the lower blade guard does not cover the blade, exposing it on the underside of work. Keep your hands and fingers away from cutting area. Any part of your body coming in contact with the moving blade will result in serious injury.

After you complete your cut release the trigger and allow the blade to come to a complete stop. Do not remove your saw from workpiece while the blade is moving.

CAUTION:

To make sawing easier and safer, always maintain proper control of your saw. Loss of control of your saw could cause an accident resulting in possible serious injury.

5 4 0 5

3 0 2 2

WRONG

Fig. 15

50 45

30 22

RIGHT

Fig. 16

 

Page 14

Image 14
Contents Operators Manual Thank YOU for Buying a Ryobi Cordless Circular SAWTable of Contents Read ALL Instructions Symbol Meaning Safety Alert SymbolRules for Safe Operation When Servicing USE only Identical Replacement Parts Important Safety Rules for Battery ToolsDo not Charge Battery Tool in a Damp or WET Location Lower Blade Guard Important Safety Instructions for ChargerImportant Safety Instructions for Circular Saws Do not Operate Charger with a DamagedRules for Safe Operation Know Your Cordless Circular SAW FeaturesSwitch ApplicationsOperation Charging Battery PackBattery Charger LED Function of ChargerBattery Pack Charger Green Light on Indicates Fully ChargedTo Install Battery Pack To Assemble or Remove BladeTo Remove Blade SAW BladesBlade Guard System To Lessen the Chance of Kickback KickbackKickback is Caused by KickbackStarting a CUT Depth of CUT AdjustmentTo Adjust Blade Depth To Help Maintain Control Width of CUT Scale RIP Cuts Base AssemblyTo Cross CUT or RIP CUT TOP View of SAW Guideline Front of SAW Blade Guide NotchGuard To Adjust Bevel SettingBlade Guide Notch Guideline To Check To AdjustPositive 0 Bevel Stop To Pocket CUTTo RIP CUT To Assemble Optional RIP GuideBatteries MaintenanceBattery Pack Removal and Preparation for Recycling 2 in. Cordless Circular SAW Model NO. R10631 Ryobi Cordless Circular SAW Model Number R10630 Parts List