Chicago Electric 94626 INSPECTION, MAINTENANCE, and Cleaning, Replacing the Carbon Brushes

Page 11

Caution: Never pull the Saw backwards since the Saw Blade will climb out of the cut and kickback will occur.

INSPECTION, MAINTENANCE, AND CLEANING

WARNING!

Make sure the Trigger Switch of the Flush Cut Saw is in its “OFF” position, and that the tool is unplugged from its electrical outlet, before performing any inspection, maintenance, or cleaning procedures.

1.Before each use, inspect the general condition of the Saw. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use.

Do not use damaged equipment.

2.Before remounting the Saw Blade (2), remove all sawdust that has accumulated around the Safety Guard (6) and Blade Guard Frame (9).

3.Regularly inspect and tighten all mounting screws and knobs.

4.Keep Saw Blade clean and sharp. Sharp blades minimize stalling and kickback.

5.Keep guards in good working order.

6.Keep motor air vent clean of dust and debris. Vacuum periodically.

7.If the tool is not operating normally, making unusual noises, or appears defective, stop using it immediately and get it repaired.

8.Clean tool with a damp cloth and light detergent. Do not use solvents as they can damage and crack the plastic parts.

Replacing the Carbon Brushes

1.Unscrew the Carbon Brush Covers (38).

2.Pull out the Carbon Brush (36) from each side of the Motor and examine them.

If they are worn more than half way down, replace them. (An extra set is included.) It could be that they are simply dirty. They can be cleaned using an ink eraser.

3.Replace the Carbon Brushes (36) and Brush Covers (38).

SKU 94626

For technical questions, please call 1-800-444-3353

Page 11

Image 11
Contents 8 Inch Blade TOE Kick SAW Work Area SpecificationsGeneral Safety Rules Personal Safety Electrical SafetyTool Use and Care ServiceSpecific Safety Rulles for this Product SKU Grounded Tools with Three Prong Plugs GroundingExtension Cords Double Insulated Tools with Two Prong PlugsOperating Instructions SymbologyUnpacking Making Flush Cuts ControlsReplacing the Carbon Brushes INSPECTION, MAINTENANCE, and CleaningTroubleshooting Installing the Saw BladePlease Read the Following Carefully Parts ListAssembly Drawing Limited 90 DAY Warranty