BEVELCUT
C..CLAMP
Fig. 28
•Loosen the bevel lock knob and move the saw arm to the left to the desired bevel angle.
•Bevel angles can be set from 0 ° to 45 °.
•Align the indicator point with the desired angle.
•Once the saw arm has been set at the desired angle, securely tighten the bevel lock knob.
•Place the workpiece fiat on the miter table with one edge securely against the fence. If the board is warped, place the convex side against the fence. If the concave edge of a beard is placed against the fence, the beard could collapse on the blade at the end of the cut, jamming the blade.
See Figures 33 and 34.
•When cutting long pieces of lumber or molding, support the overhanging end(s) of the stock with a roller stand or with a work surface level with the saw table.
•Align the cutting line on the workpiece with the edge of saw blade.
•Grasp the stock firmly with one hand and secure it against the fence. Use a
&WARNING: To avoid serious personal injury, keep your hands outside the no hands zone; at
least 3 in. from blade. Never perform any cutting operation freehand (without holding workpiece against the fence). The blade could grab the workpiece if it slips or twists.
Before turning on the saw, perform a dry run of the cuffing operation just to make sure that no problems will occur when the cut is made.
Grasp the saw handle firmly, press the
lever down, then squeeze the switch trigger. Allow several seconds for the blade to reach maximum
speed.
Slowly lower the blade into and through the workpiece. See Figure 28..
Release the switch triggerand allow the saw blade to stop rotating before raising the blade out of workpiece. Wait until the electric brake stops blade from turning before removing the workpiece
from miter table.
COMPOUND MITER CUT
See Figures 29 and 30.
A compound miter cut is a cut made using a miter angle and a bevel angle at the same time. This type of cut is used to make picture frames, cut molding, make
boxes with sloping sides, and for certain roof framing cuts.
To make this type of cut the miter table must be rotated to the correct angle and the saw arm must be tilted to the correct bevel angle. Care should always be taken when making compound miter setups due to the interaction of the two angle settings.
Adjustments of miter and bevel settings are interde- pendent with one another. Each time you adjust the miter seffing you change the effect of the bevel setting. Also, each time you adjust the bevel setting you change the effect of the miter setting.
It may take several settings to obtain the desired cut. The first angle setting should be checked after setting
the second angle, since adjusting the second angle affects the first.
Once the two correct settings for a particular cut have been obtained, always make a test cut in scrap material before making a finish cut in good material.
22