Craftsman 137.21214 operating instructions Carton Contents

Page 7

CARTON CONTENTS

UNPACKING YOUR MITER SAW

To avoid injury from unexpected starting or electrical shock, do not plug the power cord into a source of power during unpacking and assembly. This cord must remain unplugged whenever you are adjusting/assembling the saw.

1.Remove the miter saw from the carton. IMPORTANT: Do not lift the miter saw by the switch handle or miter table handle. It may cause misalignment. Lift only by the built-in carry handle located at the top of the machine.

2.Place the saw on a secure stationary work surface.

3.Separate all parts from the packing material. Check each one with the illustration below to make certain all items are accounted for, before discarding any packing material.

If any part is missing or damaged, do not attempt to assemble the miter saw, or plug in the power cord until the missing or damaged part is correctly replaced. To avoid electric shock, use only identical replacement parts when servicing double insulated tools.

Dust Bag

Hold-down Clamp	Extension Wings &
Hold-down Clamp	Stop Block	Extension Wing	Blade Wrench
	Miter Table	Extension Wing
	Miter Table	Locking Screws
	Handle	Locking Screws
	Handle

7

Image 7

Contents Part No.137212140001 With Laser TracTable of Contents General Safety Instructions Power Tool SafetyElectrical Requirements Compound Miter SAW SafetySpecific Safety Instructions for this Compound Miter SAW Power Supply and Motor SpecificationsGuidelines for Extension Cords Electrical Requirements and SafetyMotor Safety Protection Double InsulatedRecommended Accessories Accessories and Attachments Tools Needed for AssemblyAccessories Carton Contents Know Your Compound Miter SAW Woodworking Terms Glossary of TermsAssembly and Adjustments Removing or Installating the Blade Installing Extension Wings FIG. EInstalling the Stop Block FIG. E Installing the Extension Wings FIG. EInstalling Blade Fig. F, G, H Installing the HOLD-DOWN Clamp FIG. H-1Miter Scale FIG. J Cutting ARM Travel FIG. K To Adjust Miter AnglesCutting arm pivot adjustment 90o Bevel Pointer Adjustment Fig. NFig. N Operation Safety Instructions for Basic SAW OperationsInspect Your Workpiece Dress for SafetyWhen SAW is Running Plan Your WorkOperation of Laser Body and Hand Position FIG. PTurning the SAW on Fig. Q Laser -TRACCutting Bowed Material FIG. U Miter CUT FIG. RBevel CUT FIG. S Compound CUT FIG. TAuxilary Wood Fence FIG. W Workpiece Support FIGVertical Miter Cutting FIG. Y Cutting a Dimensional 4X4 with ONE CUT FigCutting Base Molding FIG. Z Changing the Batteries Fig. CC Bevel/Miter SettingsChanging the Laser Batteries Cutting Crown Molding FIG. AA, BBMaintenance Problem Problem Cause Suggested Corrective Action Troubleshooting GuideTroubleshooting Guide Motor Troubleshooting Guide SAW OperationParts List for Schematic a Miter SAW Parts ListParts Compound Miter SAW Schematic aDescription Size QTY Parts List for Schematic B MotorSchematic B Motor Get it fixed, at your home or ours