OPERATION
■When making a cut use steady, even pressure. Never force cuts.
■Do not cut warped or wet lumber.
■Always hold your saw firmly with both hands and keep your body in a balanced position so as to resist the forces of kickback should it occur.
When using your saw, always stay alert and exercise control. Do not remove your saw from workpiece while the blade is moving.
DEPTH OF CUT ADJUSTMENT
Always keep correct blade depth setting. The correct blade depth setting for all cuts should not exceed 1/4 inch below the material to be cut. More blade depth will increase the chance of kickback and cause the cut to be rough. One blade tooth below the material to be cut works best for most efficient cutting action.
TO ADJUST BLADE DEPTH
■Remove battery pack from saw.
WARNING: Failure to remove battery pack from saw could result in accidental starting causing possible serious personal injury.
TO RAISE
SAW
TO
TIGHTEN
TO LOWER |
SAW |
DEPTH
ADJUSTMENT
KNOB
BASE | TO |
|
ASSEMBLY | Fig. 15 | |
| LOOSEN |
■Loosen depth adjustment knob. See Figure 15.
■Hold base flat against the workpiece and raise or lower saw until the required depth is reached.
■Tighten depth adjustment knob securely.
STARTING A CUT
Know the right way to use your saw.
See Figure 16.
50 45
30
2
3
3
1
45
0
1
Fig. 16
Never use your saw as shown in figure 17.
50 45
30
2
3
3
1
45
0
1
WRONG | Fig. 17 |
Never place your hand on the workpiece behind your saw while making a cut.
WARNING: To make sawing easier and safer, always maintain proper control of your saw. Loss of control of your saw could cause an accident resulting in possible serious injury.
15