3 DISASSEMBLY/ASSEMBLY INSTRUCTIONS
■HOW TO DISASSEMBLE KEYLESS CHUCK.
Ref. No. 1A | Procedure 1A | Removal of the Keyless Drill Chuck. | |
|
| NOTE : |
|
|
| When attaching or removing a bit, disconnect battery pack from | |
|
| tool. |
|
|
| 1. Set the clutch handle to position | and select "LOW" position. |
|
| 2. Turn the lock collar counterclockwise (looking from the front) to | |
|
| open the chuck jaws. |
|
|
| 3. Use a screwdriver to turn the chuck fastening screw inside the | |
|
| chuck clockwise direction of the arrow, and remove the screw. (See | |
|
| Fig. 1) |
|
|
| NOTE : |
|
|
| If the chuck fastening screw will not come loose, insert the | |
| Fig. 1 | allen wrench into the chuck and lightly tap in the clockwise | |
| direction with a hammer to tighten the chuck, and then loosen | ||
|
| the chuck fastening screw. (See Fig. 2) | |
Insert the allen wrench into the chuck, and turn counterclockwise direction in the arrow with holding the unit by the vise to remove the chuck. (See Fig. 3)
Fig. 2
Fig. 3
3