900469 -
A B C
Fig. 5
•Green light (A) glows continuously and red light (B) flashes: indicates that the battery pack is receiving a “Fast Charge”, but the battery pack voltage is low. It is not unusual for a new, or a fully discharged battery pack to give this indication for the first several minutes of charge. If the red light continues to flash throughout the charge cycle, it indicates that the pack is weak and will provide reduced performance (the pack is still useable, but will not provide maximum power or work per charge). This battery pack will probably require replacement in the near future.
•Green light (A) continues to flash and red light (B) flashes: indicates that the battery pack has failed (pack is not chargeable and requires replacement).
INSTALLING OR REMOVING BATTERY PACK
TO REMOVE BATTERY PACK: Depress the battery release button (B) Fig. 6, and pull battery pack out of tool.
TO INSTALL BATTERY PACK: Align rails (A) Fig. 6, on battery pack with slots on tool and push battery pack onto tool until it locks in place.
A
B
Fig. 6
HOW TO HOLD THE DRIVER/DRILL
WARNING: The front end of the Driver/Drill may be made live if the tool drills into live wiring in the wall. TO PREVENT ACCIDENTAL ELECTRICAL SHOCK, DRIVER/DRILL MUST BE HELD AS SHOWN IN FIG. 7.
GENERAL DRILLING
1.Set torque adjusting collar for drilling operation and set speed selector to appropriate speed.
2.Be sure drill bit is securely gripped in chuck.
9