P 10/12
Wiring diagram
Model 6411 (without Variable speed control and Reverse switch)
Machines With Choke Coil
Important: Do not put slack portion of any Lead wire in the space surrounded by Field and Brush holders. Otherwise Lead wires will be broken by rotating Armature.
Note: 1) Some countries do not use Noise suppressor.
2) Put Choke coils and Noise suppressor (if used) in place as illustrated in Fig.
Fig. D-4
Lead wires
Choke coil lead wire (purple) to Brush holder
Choke coil lead wire (purple) to No.1a Terminal of Switch
Choke coil lead wire (orange) to Brush holder
Choke coil lead wire (orange) to Field
Field lead wire (black) to No.2a Terminal of Switch
See "Connecting Lead wire to Brush holder".
Brush holder
Put slack portion of Lead wire 
in the space between Brush holder and inside wall of Housing (L). Otherwise the Lead wire will touch rotating Armature.
Fix two Lead wires 
with this Lead wire holder.
Choke coil
(with purple Lead wires)
boss A 
boss B
See "Connecting Lead wire to Brush holder". 
Field
Route Lead wires | Switch |
between these ribs. |
|
| Route Lead wires |
| under Brush holder. |
Choke coil |
|
(with orange Lead wires) | Noise suppressor |
| |
| [if used] |
| Power supply cord |
Connecting Lead wire to Brush holder 1) Brush holders are not reversible
when assembled to Housing (L). Terminal insertion hole of each Brush holder must be positioned
outside boss A/boss B.
boss A
Terminal
Brush holder
2) Do not route each Lead wire
inside boss A/boss B.
boss B