Drilling operation
Drilling in wood
When drilling in wood, best results are obtained with wood drills equipped with a guide screw. The guide screw makes drilling easier by pulling the bit into the workpiece.
0Drilling in metal
To prevent the bit from slipping when starting a hole, make an indentation with a center- punch and hammer a t the point to be drilled. Place the point of the bit in the indenta- tion and start drilling.
Use a cutting lubricant when drilling metals. The exceptions are iron and brass which should be drilled dry.
CAUTION :
*Pressing excessively on the tool will not speed up the drilling. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool.
*There is a tremendous force exerted on the tool/bit a t the time of hole break through. Hold the tool firmly and exert care when the bit begins to break through the workpiece.
*Always grip the small workpiece firmly with a vise or a holding means.
*A stuck bit can be removed simply by setting the reversing switch to reverse rotation in order to back out. However, the tool will pull away easily unless you hold it firmly before starting the tool.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
To maintain product SAFETY and RELlABl LITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
I The accessories listed in this manual are available at an extra cost from your Makita distributor or Makita factory I service center Service centers are listed on the warranty card packed with your tool
CAUTION :
These accessories o r attachments are recommended f o r use w i t h y o u r Makita t o o l specified in this manual. The use o f any other accessories or attachments m i g h t present a risk of i n j u r y t o persons. The accessories or attachments should be used o n l y i n the proper and intended manner.
Chuck key | Grip 32 |
Part No. 763420 - 6 | Part No. 273406 - 7 |
6