Installing or removing driver bit or drill bit
CAUTION :
Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the bit.
Hold the ring and turn the sleeve counter- | Sleeve | |
clockwise to open the chuck jaws. Place | ||
| ||
the bit in the chuck as far as it will go. |
| |
Hold the ring firmly and turn the sleeve |
| |
clockwise to tighten the chuck. |
| |
To remove the bit, hold the ring and turn |
| |
the sleeve counterclockwise. |
| |
Switch action |
| |
Tool speed is increased by increasing pres- |
| |
sure on the trigger. To start the tool, simply |
| |
pull the trigger. Release the trigger to stop. |
|
CAUTION :
Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released.
Reversing switch action
This tool has a reversing switch to change the direction of rotation. Slide the revers- ing switch to the left for clockwise rota- tion or to the right for counterclockwise.
CAUTION :
0 Always check the direction of rotation before operation.
0 Move the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool.
8