Makita 6223DWE Adjusting the fastening torque, Installing set plate, Screwdriving operation

Page 10

CAUTION:

Always withdraw the tool from the workpiece before resuming operation. If the tool can- not be withdrawn, hold the tool firmly when turning on the tool, to overcome a strong reaction

Adjusting the fastening torque

 

Pointer ---, ,---Drill marking

The fastening torque can be adjusted in six

 

stages by turning the adjusting ring so that

 

the pointer on the adjusting ring points to a

 

 

 

number on the tool body. The fastening

 

 

 

torque is minimum when the pointer points

 

 

 

to the number 1 and maximum when it

 

 

 

points to the at- marking. The clutch will

 

 

 

slip at varying torque levels when the point-

 

 

 

er is set at the numbers 1 to 5. The clutch

-

 

 

is designed not to slip at the ax- marking.

I

I I 1

your material or a piece of duplicate mate for a particular application.

The adjusting ring cannot be locked with the pointer positioned half-way between the numbers.

Installing set plate

Always install the set plate when using bat- Screw tery cartridges 1200, 1202 or 1202A. Install

the set plate on the tool with the screw provided.

Set plate

Screwdriving operation

Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase the speed gradually. Release the trigger as soon as the clutch cuts in.

__~

10

Image 10
Contents Model 6223DE Model 6223DWE Personal Safety Electrical SafetyWork Area Service Tool Use and CareSpecific Safety Rules Symbols Important Safety Instructions For Charger Additional Safety Rules Installing or removing battery cartridge ChargingSwitch action Installing or removing driver bit or drill bitReversing switch action Installing set plate Adjusting the fastening torqueScrewdriving operation Drilling operation Maintenance Method of disposalAccessories Page Cordless Driver Drill Makita Limitedone Year Warranty