Makita 6202DW instruction manual Installingor removing driver bit or drill bit

If you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a location exposed to direct sunlight or heat for a long time, the charg- ing light may flash in red color. If this occurs, wait for a while. Charging will begin after the battery cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge from the fast charger.

If the charging light flashes alternately in green and red color and a tone sounds "beep, beep, beep, . . ." for about 20 seconds, a problem exists and charging is not possible. The terminals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged.

If you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger.

Installingor removing driver bit or drill bit

CAUTION :

Always be sure that the tool is switched off and the battery cartridge i s removed before installing or removing the bit.

To install the bit, push the sleeve up to- ward the "FREE" side and turn the sleeve counterclockwise while holding the ring with your other hand as illustrated a t right.

A -FREEside

L

\LOCK side

\-Ring

Place the bit in the chuck as far as it will go. Hold the ring firmly and turn the sleeve clockwise to tighten the chuck. Then push the sleeve down toward the "LOCK" side. See illustration.

To remove the bit, push the sleeve up toward the "FREE" side and turn the sleeve counterclockwise while holding the ring with your other hand.

CAUTION :

0 Do not attempt to turn the sleeve forcibly when the sleeve is in the "LOCK" position. The sleeve may be damaged.

.Always push the sleeve down toward the "LOCK" side before operation. If you operate the tool with the sleeve in the"FREE" position, the chuck may loosen and the bit may come out unexpectedly.

8