Specifications, Symbols, EC Declaration of Conformity

ENGLISH (Original instructions)

SPECIFICATIONS

	Model		6409/6409N	6410
Capacities		Steel	10 mm	10 mm
Capacities		Wood	25 mm	25 mm
		Wood	25 mm	25 mm
	No load speed (min-1)		2,200	0 - 2,200
	Overall length		248 mm	248 mm
	Net weight		1.2 kg	1.2 kg
	Safety class			/II

•Due to our continuing programme of research and development, the specifications herein are subject to change without notice.

•Specifications may differ from country to country.

•Weight according to EPTA-Procedure 01/2003

END201-5

Symbols

The following show the symbols used for the equipment. Be sure that you understand their meaning before use. ･ Read instruction manual.

･ DOUBLE INSULATION

･ Only for EU countries

Do not dispose of electric equipment together with household waste material! In observance of European Directive 2002/96/EC on waste electric and

electronic equipment and its implementation in accordance with national law, electric equipment that have reached the end of their life must be collected separately and returned to

an environmentally compatible recycling facility.

ENE032-1

Intended use

The tool is intended for drilling in wood, metal and plastic.

ENF002-1

Power supply

The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire.

ENG104-1

For European countries only

Noise

The typical A-weighted noise level determined according to EN60745:

Sound pressure level (LpA) : 79 dB(A)

Uncertainty (K) : 3 dB(A)

The noise level under working may exceed 80 dB (A).

Wear ear protection.

ENG202-3

Vibration

The vibration total value (tri-axial vector sum) determined according to EN60745:

Work mode: drilling into metal

Vibration emission (ah,D) : 2.5 m/s2 or less

Uncertainty (K) : 1.5 m/s2

ENG901-1

•The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another.

•The declared vibration emission value may also be used in a preliminary assessment of exposure.

WARNING:

•The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which the tool is used.

•Be sure to identify safety measures to protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time).

ENH101-12

EC Declaration of Conformity

We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s):

Designation of Machine: Drill

Model No./ Type: 6409,6409N,6410 are of series production and

Conforms to the following European Directives: 98/37/EC until 28th December 2009 and then with 2006/42/EC from 29th December 2009

And are manufactured in accordance with the following standards or standardised documents:

EN60745