HOW TO USE
Charging
Connect the charging plug to the charg- ing connector, then plug in the charger to the power receptacle. Charging takes 3 hours.
CAUTION:
The battery in your new tool is not fully charged. You will need to charge it be- fore use.
Do not operate the tool during charging.
Overcharging more than 2 days consid- erably shortens the battery service life.
Always unplug the charger after completing the charge.
When you charge a new tool or a tool which has not been used for a long period, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the tool fully after discharging it almost completely a couple of times.
Installing and removing bit
To install the drill bit, place it in the chuck as far as it will go. Tighten the chuck collar by hand. Place the cuck key in each of three holes, and tighten clockwise.
To remove the drill bit, place the chuck key into the chuck hole and turn counter- clockwise.
CAUTION :
Always set the
6