Sleeve

CAUTION :

.The fast charger Model DC1201 i s for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer's batteries.

0 When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharg- ing it completely and recharging a couple of times.

0 If you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a location exposed to direct sunlight or heat for a long time, the charg- ing light may flash in red color. If this occurs, wait for a while. Charging will begin after the battery cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge from the fast charger.

If the charging light flashes alternately in green and red color and a tone sounds "beep, beep, beep,. . ." for about 20 seconds, a problem exists and charging i s not possible. The terminals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged.

0 If you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger.

Installing or removing bit

CAUTION :

Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the bit.

Use only the driver bit or socket bit shown in the figure.

Do not use any other driver bit or socket bit.

To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. Then release the sleeve to secure the bit.

To remove the bit,pull the sleeve in the direction of the arrow and pull the bit out firmly.