0 If you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger.
Installing or removing drill bit or driver bit
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the bit.
To install the bit, place it in the chuck as | Chuck key | I |
far as it will go. Tighten the chuck by hand. | ||
Place the chuck key in each of the three |
| |
holes and tighten clockwise. Be sure to |
|
|
tighten all three chuck holes evenly. |
|
|
To remove the bit, turn the chuck key |
|
|
counterclockwise in just one hole, then |
|
|
loosen the chuck by hand. |
|
|
Holding tool
Hold the tool as shown in the figure.
When drilling a large diameter hole, hold the tool firmly with both hands.
7