Labels on tools
Warning! To reduce the risk of injury, the user must read the instruction manual.
Additional safety instructions for batteries and chargers
Batteries
Never attempt to open for any reason. Do not expose the battery to water. Do not expose the battery to heat.
Do not store in locations where the temperature may exceed 40 °C.
Charge only at ambient temperatures between 10 °C and 40 °C.
Charge only using the charger provided with the tool. When disposing of batteries, follow the instructions given in the section "Protecting the environment".
Chargers
Use your Black & Decker charger only to charge the battery with which it was supplied. Other batteries could burst, causing personal injury and damage.
Never attempt to charge
Do not expose the charger to water. Do not open the charger.
Do not probe the charger.
Features
1.Keyless chuck
2.Torque adjust collar (VPX1212)
3.Speed selector switch
4.Forward/reverse and
5.Battery release button (on battery)
6.Battery compartment
7.Variable speed trigger switch
8.Torque adjust collar (VPX1222)
Fig. A
14. Low battery indicators
Assembly
Installing the battery pack (fig. A)
Warning! Make sure that the
Insert the metal terminal end of the battery pack (9) into the battery compartment (6) until you hear the lock click into place and the VPXTM logo shows through the window.
Warning! The battery will only fit one way, do not force it. If the battery does not fit, remove it and put it in the other way.
Removing the battery pack (fig A)
Press the battery pack release button (5) and firmly pull the battery pack (9) out of the battery compartment (6).
+40ºC
+10ºC
The charger is intended for indoor use only.
Read the instruction manual before use.
The charger automatically shuts off if the ambient temperature becomes too high. As soon as the ambient temperature has cooled down, the charger will resume operating.
Charge only at ambient temperatures between 10 °C and 40 °C.
Charging.
Charging the batteries (fig. B)
Warning! Do not charge battery packs at ambient temperatures below 10 °C or above 40 °C.
Note: The charger will not charge a battery pack if the cell temperature is below approximately 0° C or above 60° C. The battery pack should be left in the charger and the charger will begin to charge automatically when the cell temperature warms up or cools down.
Plug in the charger (10) and switch on at the mains. Insert the battery pack (9) into the charger. Make sure that the battery pack is fully seated in the charger (10). The charging indicator (11) will flash continuously (slowly).
Leave the battery to charge for at least 5 to 6 hours. The charge is complete when the charging indicator
Electrical safety
This charger is double insulated; therefore no earth wire is required. Always check that the power
supply corresponds to the voltage on the rating plate.
If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard.
(11) lights continuously
The charger and the battery pack can be left connected indefinitely with the LED illuminated. The LED will change to flashing (charging) state, as the charger occasionally “tops off“ the battery charge.
The charging indicator (11) will be lit as long as the battery pack is connected to the
6 |