Centerposition L, To Install Battery Pack

SWITCH

See Figure 2.

To turn your drill ON, depress the switch trigger. To turn it OFF, release the switch trigger.

CENTERPOSITION L I .[

(LOCK)

TO INSTALL BATTERY PACK

•Lock switch trigger on your drill by placing the direction of rotation selector in center position. See Figure 2.

•Place battery pack in your drill. Align raised rib inside drill with groove on battery pack.

See Figure 4.

Fig. 2

VARIABLE SPEED

This tool has a variable speed switch that delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.

Note: You might hear a whistling or ringing noise from the switch during use. Do not be concerned, this is a normal part of the switch function.

TWO-SPEED GEAR TRAIN

See Figure 3.

Your drill has a two-speed gear train designed for drilling or driving at HI or LO speeds. A slide switch is located on top of your drill to select either HI or LO speed. When using drill in the HI speed range, speed will increase and unit will have less power and torque. When using drill in the LO speed range, speed will decrease and unit will have more power and torque. Use HI speed for fast drilling or driving applications and LO speed for high power and torque applications.

LO SPEED TWO SPEED

HI SPEED

,_GEARTRAIN (HI-LO)

Fig. 3

BATTERYPACK

LATCHES

	DEPRESSLATCHESTO	Fig. 4
	RELEASEBATTERYPACK	Fig. 4
	RELEASEBATTERYPACK

•Make sure the latches on each side of your battery pack snap in place and battery pack is secured in drill before beginning operation.

_k CAUTION: When placing battery pack in your drill, be sure raised rib inside drill aligns with

groove on battery pack and latches snap in place properly. Improper assembly of battery pack can cause damage to internal components.

TO REMOVE BATTERY PACK

•Lock switch trigger on your drill by placing the direction of rotation selector in center position. See Figure 2.

•Locate latches on end of battery pack and depress to release battery pack from your drill.

See Figure 4.

•Remove battery pack from your drill.