OPERATION
KNOW YOUR DRILL
See Figure 1_
Before attempting to use your drill, familiarize
yourself with el! operating features and safety re- quirements,
If any pads are missing do not operate your drill untie the missing parts are replaced.
CHARGING YOUR DRILL
Your drill has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge tt at least 5 hours prior to use
NOTE:Your drill wltl not reach fult charge the first ttme it is charged. Allow several cycles (drilling followed by recharging) for your drill to become fully charged,
DRILL
SELECTOR
TO CHARGE
1, Connect charger to your drill by inserting charger plug Into input jack, NOTE: As shown In Figure 1, input Jack is located at the rear of toot
2Charger can be used with normal house voltage of 110.120 volts, 60 Hz. AC only.
3, Connect charger Io power supply
NOTE: The LED indicator, which is located above the switch, will iight up when charger is properly con. nected to power supply Thts light indicates your drill is charging and will rematn on until charger ts disconnected from power supply.
NOTE: Do not operate your drill while it is connected
to the charger. The driving ability of your drill will not increase,
NOTE: After normal usage, your drtlI usually requires 3 hours of charging time to be fully charged
YOUR DRILL _ONTAINS SPECIAL
HIGH TEMPERATURE BATTERIES TO HELP PRE-
VENT BATTERY DAMAGE WHEN LEFT ON
CHARGE FOR EXTENDED PERIODS OF TIME,
HOWEVER, ONCE THE BATTERIES OF YOUR DRILL
BECOME FULLY CHARGED, WE RECOMMEND
THAT YOU UNPLUG YOUR CHARGER FROM
POWER SUPPLY THEN DISCONNECT THE CHARGER FROM YOUR DRILL..
UT JACK
CHARGER PLUG
LED INDICATOi_i// BATTERY CHARGER
l
SWITCH TRIGGER
WRIST STRAP
Page 5